Bài giảng Network - Chapter 12

Chapter Overview Using Remote ConnectionsSLIP and PPPWAN Technologies 1Types of Remote Network Connections Computer to Internet service provider (ISP)Computer to private networkComputer to computerNetwork to network 2Public Switched Telephone Network (PSTN) Technical name for the standard voice telephone systemAlso known as the Plain Old Telephone Service (POTS)Analog, circuit-switched networkWorks with asynchronous modems to transmit data between computers at almost any locationTypically uses copper-based, twisted-pair cable with RJ-11 jacks 3Modems A modem (modulator/demodulator) is required to convert a computer’s digital signals to the analog signals used by the PSTN.At the other end of the connection, another modem converts the analog signals back to digital. 4Modem Communications 5Configuring a Modem Most modems support the Plug and Play standard.Modems typically need an interrupt request (IRQ) and an input/output (I/O) port to communicate with the computer. For external modems, the IRQ and I/O port are assigned to the serial port. For internal modems, you configure the device itself to use specific hardware resources. Serial ports use a chip called a universal asynchronous receiver-transmitter (UART) to manage communications. For today’s high-speed modems, you should always use a 16550 UART. 6Virtual Private Network (VPN) Communications The remote user connects to the Internet by using a modem to dial in to a local ISP.The network is permanently connected to the Internet and has a server that is configured to receive incoming VPN connections.The remote computer and the network server establish a secured connection across the Internet. This technique is called tunneling, because the connection runs across the Internet inside a secure conduit. 7Point-to-Point Tunneling Protocol (PPTP) Encapsulation 8Integrated Services Digital Network Integrated Services Digital Network (ISDN) is a high-speed digital dial-up service that uses the standard PSTN infrastructure.It is used primarily for Internet connections, but it also supports special devices such as ISDN telephones and fax machines.The Basic Rate Interface (BRI) provides two 64-Kbps B channels and one 16-Kbps D channel.The Primary Rate Interface (PRI) provides 23 64-Kbps B channels and one 64-Kbps D channel.For computer connections, ISDN requires a Network Terminator 1 (NT-1) and a terminal adapter. 9ISDN Connections 10DSL Service Types Service Transmission Rate Link Length Applications High-bit-rate Digital Subscriber Line (HDSL) 1.544 Mbps full-duplex (using two wire pairs) or 2.048 Mbps full-duplex (using three wire pairs) 12,000 to 15,000 feet Used by large networks as a substitute for T-1 leased line connections, LAN and private branch exchange (PBX) interconnections, or frame relay traffic aggregation Symmetrical Digital Subscriber Line (SDSL) 1.544 Mbps full-duplex or 2.048 Mbps full-duplex (one wire pair) 10,000 feet Same as HDSL Asymmetrical Digital Subscriber Line (ADSL) 1.544 to 8.448 Mbps downstream; 16 Kbps to 640 Kbps upstream 10,000 to 18,000 feet Internet/intranet access, remote LAN access, virtual private networking, video on demand, Voice over IP 11DSL Service Types (Cont.) Service Transmission Rate Link Length Applications Rate-Adaptive Digital Subscriber Line (RADSL) 640 Kbps to 2.2 Mbps downstream; 272 Kbps to 1.088 Mbps upstream 10,000 to 18,000 feet Same as ADSL, except that the transmission speed is dynamically adjusted to accommodate the link length and signal quality ADSL Lite Up to 1 Mbps downstream; up to 512 Kbps upstream 18,000 feet Internet/intranet access, remote LAN access, IP telephony, videoconferencing Very high-bit-rate Digital Subscriber Line (VDSL) 12.96 to 51.84 Mbps downstream; 1.6 to 2.3 Mbps upstream 1000 to 4500 feet Multimedia Internet access, high- definition television delivery ISDN Digital Subscriber Line (IDSL) Up to 144 Kbps full-duplex 18,000 feet Internet/intranet access, remote LAN access, IP telephony, videoconferencing 12ADSL Connections 13CATV Networks Broadband networks owned by cable television companiesProvide Internet access through the same cable used for television signalsRun at 512 Kbps or more Bandwidth shared with other users in the areaAsymmetrical transmissionsProvide Internet connections only 14CATV Connections 15Satellite Connections Provide Internet access onlyUsually downstream onlyRequire a dial-up connection for upstream trafficNot suitable for private network connections 16Thin Client Computing Thin client computing is a terminal client program running on a computer or dedicated network client device that communicates with a terminal server elsewhere on the network.The client provides the interface to the operating system and nothing more. The actual operating system and all applications run on the terminal server. Thin client computing uses a specialized protocol, such as Independent Computing Architecture (ICA), developed by Cyrix Systems, Inc. ICA carries keystrokes, mouse actions, and screen updates between the client and the server, so that the applications appear to be running locally. 17Remote Connection Requirements Common protocols. The two computers to be connected must share common protocols at the data-link layer and above. TCP/IP configuration. The Internet Protocol (IP) address and other configuration parameters must be appropriate for the network.Host and remote software. The remote computer must run a client program that can use the physical layer to establish a connection.The host computer must run a program that can respond to connection requests and provide network access. Security. The host computer and the other systems on the network must have security mechanisms that control access to network resources. 18SLIP and PPP Characteristics Open Systems Interconnection (OSI) data-link layer and TCP/IP link layer protocolsEnd-to-end protocolsNo physical layer specifications 19SLIP Stands for Serial Line Internet ProtocolSimple protocol used for transmissions over serial connectionsProvides no error detection, network layer protocol identification, or securityTransmits an IP datagram and follows it with a single End Delimiter byteRarely used today because Point-to-Point Protocol (PPP) has replaced it 20The SLIP Frame 21PPP Stands for Point-to-Point ProtocolUsed for dial-up Internet connections and other wide area network (WAN) technologiesMore complex than SLIPProvides additional services that SLIP lacks, such as IP address exchange, multiplexing of network layer protocols, and authentication Uses a 5-byte header 22The PPP Frame 23Phases of the PPP Connection Establishment Procedure 1. Link dead2. Link establishment3. Authentication4. Link quality monitoring5. Network layer protocol configuration6. Link open7. Link termination 24WAN Characteristics WANs typically connect networks at different locations.WANs are point-to-point links that do not use a shared medium.WANs can use PSTN, ISDN, or DSL connections.To connect local area networks (LANs) at remote locations, you install a router at each site and connect them with a WAN link.Most WAN connections use PPP at the data-link layer.WAN links usually involve a third-party service provider, which often makes high-speed WANs slower than LANs. 25Leased Lines A leased line is a permanent analog or digital telephone connection between two locations that provides a predetermined amount of bandwidth. The most common leased line in the US is the T-1, which runs at 1.544 Mbps.The European equivalent of a T-1 is the E-1, which runs at 2.048 Mbps. Leased line services are split into 64-Kbps channels.You can use each channel as an individual 64-Kbps link, or combine them into a single data pipe.Leasing part of a T-1 (in 64-Kbps increments) is called fractional T-1 service. A T-3 connection runs at 44.736 Mbps and an E-3 runs at 34.368 Mbps. 26Installing a Leased Line A telephone service provider furnishes a link between two sites, running at a specific bandwidth.Prices are based on the amount of the bandwidth and the distance spanned.Each end of a leased line must be connected to a channel service unit/data service unit (CSU/DSU). To use the line, you connect the CSU/DSU to your network, using a router. 27Frame Relay Frame relay provides bandwidth similar to that of a leased line, but with greater flexibility.Speeds range from 56 Kbps to the equivalent of a T-3.Frame relay links are not locked into a specific speed.Each site is connected to the service provider’s network, called a cloud.The two sites are linked by a dynamic connection through the cloud.Each site requires a hardware device called a frame relay assembler/disassembler (FRAD). 28SONET Optical Carrier (OC) Levels OC Level Data Transmission Rate (in Mbps) OC1 51.84 OC3 155.52 OC6 311.04 OC9 466.56 OC12 622.08 OC18 933.12 OC24 1244.16 OC36 1866.24 OC48 2488.32 OC96 4976.640 OC192 9953.280 29ATM Stands for Asynchronous Transfer ModeOriginally designed to carry voice, data, and video traffic on both LANs and WANsUses fixed-length, 53-byte frames called cellsProvides a connection-oriented, full-duplex, point-to-point service between devicesUses no broadcast transmissions Data relayed between networks by switches, not routersSpeeds: range from a 25.6-Mbps service, intended for desktop LAN connections, to 2.46 Gbps 30Chapter Summary Using remote connectionsStand-alone computers become remote clients when they connect to a distant network by using any one of several different technologies. PSTN connections use modems and standard telephone lines to transmit data. They are relatively slow but also flexible and universal. VPNs are secure tunnels through the Internet that enable remote computers to communicate with their networks without using long-distance telephone connections. SLIP and PPP SLIP is a simple protocol that enables two systems connected through their serial ports to exchange messages with very little control overhead. PPP is a more complicated end-to-end protocol that enables two systems to negotiate the use of optional features such as authentication protocols and multiple network layer protocols. 31Chapter Summary (Cont.) WAN technologies Leased lines are dedicated, permanent, point-to-point connections between two sites that are provided by telephone carriers. Frame relay is a service that uses a cloud of virtual circuits to provide flexible amounts of bandwidth between sites. SONET is a fiber optic telecommunications network standard consisting of a series of optical carrier levels. ATM is a switched, connection-oriented service that was designed for use on both LANs and WANs. 32